Omniadisce

Tune a speed controller

Problem Expert New no attempts yet
A fan must spin at a target speed of 100 rad/s. A controller measures the speed, compares it with the target, and sets the fan's drive voltage. The fan responds slowly: its speed settles towards 10 rad/s per volt of drive, with a time constant of 2 s.

The controller has two terms:
- proportional: drive = $K_p \times$ error, where error = target โˆ’ speed. More error, more push.
- integral: an extra drive that keeps growing by $K_i \times$ error every second, for as long as any error remains.

With the proportional term alone (the start: $K_p = 0.5$, $K_i = 0$) the fan stops short at 83 rad/s: once the error is small, the push is too small to hold the speed. The integral term removes that leftover error, but too much of it makes the speed overshoot and swing.

How to do it:
1. Play the start setting: the speed stops at 83 rad/s. That leftover error is what the integral term fixes.
2. Raise Ki in small steps (0.02, 0.05, 0.1), playing each time. Watch the end speed and the peak.
3. If it overshoots past 105, lower Ki or Kp; if it is too slow at 10 s, raise Ki.
4. When all three dashed-line requirements are met, press Check my answer.
Question
What proportional and integral gains meet all three requirements?

Join free to take this activity

Anyone can look around, but taking an activity needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

It is part of the course Electrical engineering: from first circuits to the power grid.

Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view