A copper cube $4\ \text{cm}$ on each side is heated to $200\ °\text{C}$ and dropped into a glass tank of water at $20\ °\text{C}$. The tank is $10\ \text{cm} \times 10\ \text{cm}$ inside and well insulated, so the only heat that moves is from the copper to the water.
Copper has a density of $8960\ \text{kg/m}^3$ and a specific heat of $385\ \text{J/(kg·K)}$. Water has a density of $998\ \text{kg/m}^3$ and a specific heat of $4182\ \text{J/(kg·K)}$. In the simulation, heat runs 60 times faster than the motion, so the 8-second run shows 8 minutes of cooling.
Principles it rests on
Heat taken in or given out: $Q = m\,c\,\Delta T$.
In an insulated container, the heat the hot body loses is the heat the cold one gains, until both reach the same temperature.
Water's specific heat is about ten times copper's, so a little water takes in a lot of heat for each degree it warms.
Question
How deep must the water in the tank be so that, once the block and the water reach the same temperature, the water is at 30 °C?
Your setup must satisfy
The water ends up at 30 °C (± 0.4)
The block has cooled to the water's temperature (at most 31.5 °C)
Drag to orbit · scroll to zoom · right-drag to pan
Your settings
Hints
Solution
Step 1: The copper's mass and heat capacity $$m_{Cu} = 8960 \times 0.04^3 = 0.573\ \text{kg}, \qquad m_{Cu}\,c_{Cu} = 0.573 \times 385 = 220.8\ \text{J/K}$$
Step 2: The heat the copper gives out, cooling from 200 °C to 30 °C $$Q = 220.8 \times (200 - 30) = 37\,500\ \text{J}$$
Step 3: The water that takes in that heat, warming from 20 °C to 30 °C $$m_w = \frac{Q}{c_w\,\Delta T_w} = \frac{37\,500}{4182 \times 10} = 0.898\ \text{kg}$$
Answer: 9 cm. With 8.5 cm the water ends at 30.5 °C, and with 9.5 cm at 29.5 °C.
How fast it cools: the copper gives up most of its heat in the first minute, while it is much hotter than the water. As the two temperatures get close, the heat flows more and more slowly (Newton's law of cooling). The final temperature does not depend on how fast that happens.
How others did
Nobody has tried this yet.Be the first. Your answer starts the stats.
Only each person's first answer, given before viewing the solution, is counted.
Discussion 0 comments
Log in to join the discussion.