Omniadisce

Which landing sites are safe on snowy hills?

Simulation Intermediate New no attempts yet
Interactive 3D simulation Read the problem, then try your answer in the simulation below. Go to it
A $3\ \text{kg}$ lander must set down on hilly ground covered in snow. Four sites are marked on the map, at these positions (in metres; the lander starts above $x = 0$, $z = 0$):

  • Site A ($x = -12$, $z = 10$): a levelled pad, flat.
  • Site B ($x = 11$, $z = 15$): a slope of about $6.5ยฐ$.
  • Site C ($x = 16$, $z = 18$): a slope of about $12.5ยฐ$.
  • Site D ($x = 10$, $z = -7$): a slope of about $20ยฐ$.


The two knobs, "Landing spot x" and "Landing spot z", are where the autopilot lands: it flies over that point, descends at $2.5\ \text{m/s}$ and cuts its motors at touchdown. Each answer choice sets them to one of the sites, and in a free run you can try any spot.

Dry, the ground's friction coefficient is $0.6$; snow at this intensity cuts its grip to $44\%$ of that. The lander's feet have a friction coefficient of $0.7$. In this simulation the coefficient for a pair of surfaces is the product of the two.

A site is safe if the lander stays where it lands (it must be at rest for the last $3\ \text{s}$), tilted no more than $15ยฐ$.
Principles it rests on
  • On a slope of angle $\theta$, gravity pulls an object down the slope with $mg\sin\theta$ and presses it into the slope with $N = mg\cos\theta$.
  • Static friction can hold at most $\mu N$, so the object stays put only if $\tan\theta \le \mu$: the angle of friction.
Question
Which sites can the lander use safely?
The correct choice makes the simulation satisfy
  • The lander is at rest for the last 3 seconds (it does not slide away)
  • It ends up tilted no more than 15ยฐ
  • It is not damaged
Drag to orbit ยท scroll to zoom ยท right-drag to pan
Experiment with the settings
Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view