Omniadisce

Slide the tall crate without knocking it over

Simulation Advanced New no attempts yet
Interactive 3D simulation Read the problem, then try your answer in the simulation below. Go to it
A tall crate ($m = 20\ \text{kg}$, $0.6\ \text{m}$ wide, $1.6\ \text{m}$ high) stands on a floor. The effective coefficient of friction between crate and floor is $\mu = 0.3$. You push the back face horizontally with a force $F$ for $0.6\ \text{s}$, at a height $h$ measured from the crate's centre of mass ($h = -0.8\ \text{m}$ is the bottom edge, $h = +0.8\ \text{m}$ the top).

Push too high and the crate tips forward; push hard near the bottom and friction at its base can tip it backwards; push too gently and it barely moves. Choose $F$ and $h$ so that the crate slides at least $0.5\ \text{m}$ and never tilts more than $15ยฐ$.
Principles it rests on
  • Kinetic friction $f = \mu N = \mu m g$ opposes sliding.
  • A body that slides without rotating has zero net torque about its centre of mass.
  • The floor's normal force can act anywhere under the base, so its torque about the centre of mass is at most $N \cdot \tfrac{w}{2}$. If more torque is needed, the crate tips about an edge.
Question
Where and how hard should you push so the crate slides at least 0.5 m and stays upright?
Your setup must satisfy
  • The crate never tilts more than 15ยฐ
  • The crate ends at least 0.5 m from where it started
Drag to orbit ยท scroll to zoom ยท right-drag to pan
Your settings
Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view