Omniadisce

Capstone: a fan driver for a microcontroller

Circuit Advanced New no attempts yet
The brief. A 5 V microcontroller pin must switch a 12 V cooling fan. The fan's motor is a $24\ Ω$ winding with $10\ \text{mH}$ of inductance. The starter wires the pin straight to the gate of an N-channel MOSFET: the fan runs, but the design would not pass a review.

Your design must:
1. keep the fan at full current (450 mA to 500 mA);
2. survive switch-off: add a flyback diode, reverse-biased while running;
3. show that the fan is powered: a status LED on the 12 V rail, 5 mA to 15 mA;
4. (good practice, not graded) a ~100 Ω gate resistor to tame the switching edges, and a ~100 kΩ pull-down from gate to ground so the fan stays off while the microcontroller boots and its pin floats.

How to do it:
1. Add the flyback diode across the fan (from the MOSFET's drain to +12 V, bar towards +12 V), as in the relay lab.
2. Add the status LED with a series resistor from +12 V to the bottom wire. For 10 mA: R = (12 − 1.9) ÷ 0.01.
3. Replace the direct wire to the gate with a 100 Ω resistor, and add 100 kΩ from the gate to the bottom wire.
4. Hover over the fan's inductor to check about 0.5 A, then press Check answer.
Principles it rests on
MOSFET as a switch ($V_{GS} > V_{th}$); inductive kickback; LED current limiting; design for faults, not just for the working state.
Question
Complete the fan driver so it meets the brief.

Join free to take this activity

Anyone can look around, but taking an activity needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

It is part of the course Electrical engineering: from first circuits to the power grid.

Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view