Omniadisce

Make 5 V from a 12 V supply

Circuit Beginner New no attempts yet
A sensor input needs a $5\ \text{V}$ reference, and all you have is a $12\ \text{V}$ supply. Two resistors in series share the voltage in proportion to their resistance: this is a voltage divider.

$$V_{out} = V_{in}\,\frac{R_2}{R_1 + R_2}$$

The starter circuit uses two 1 kฮฉ resistors: it gives 6 V, not 5 V, and wastes 6 mA. The supply is a small one, so the divider may draw at most 1 mA (and at least 0.1 mA, so the reference is not swamped by noise and leakage).

How to do it:
1. The 5 V must appear across the bottom resistor, so the top one must take 12 โˆ’ 5 = 7 V.
2. Both carry the same current, so their resistances are in the same ratio as their voltages: 7 to 5.
3. Choose a current between 0.1 mA and 1 mA, say 0.5 mA. Total resistance = 12 V รท 0.0005 A.
4. Split that total in the ratio 7 : 5 between the top and the bottom resistor.
5. Set both resistors, hover over the bottom one to read its voltage, then press Check answer.
Principles it rests on
Series resistors carry the same current; Kirchhoff's voltage law; the divider formula.
Question
Choose the two resistors so one of them has 5 V (ยฑ2 %) across it, and the divider draws between 0.1 mA and 1 mA.

Join free to take this activity

Anyone can look around, but taking an activity needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

It is part of the course Electrical engineering: from first circuits to the power grid.

Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view