Omniadisce

Light an LED without burning it out

Circuit Beginner New no attempts yet
A red LED is wired straight to a 9 V battery through a 100 Ω resistor. It is far too bright, and it will not last: about 70 mA is flowing, while this LED is rated for 20 mA at most.

An LED is not a resistor. Once it conducts, the voltage across it stays close to its forward voltage, about $1.8\ \text{V}$ for a red LED, whatever the current. So the resistor takes the rest of the battery voltage, and the resistor alone sets the current: $I = (V_{battery} - V_F)/R$.

How to do it:
1. Write down what you know: battery 9 V, LED forward voltage about 1.8 V, target current about 12 mA (0.012 A).
2. The resistor gets the rest of the voltage: 9 − 1.8 = 7.2 V.
3. Ohm's law gives the resistance: R = V ÷ I = 7.2 ÷ 0.012. Work it out.
4. Pick a nearby standard value (the E12 list is in the lesson) and check its power: P = I² × R must stay under 0.25 W.
5. Double-click the resistor, enter your value, and press Check answer. In the simulator: double-click a part to change its value; hover over a part to read its voltage and current.
Principles it rests on
Kirchhoff's voltage law around the loop; Ohm's law for the resistor; power $P = I^2 R$.
Question
Change the resistor so the LED current is between 8 mA and 15 mA, and the resistor stays within its 0.25 W rating.

Join free to take this activity

Anyone can look around, but taking an activity needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

It is part of the course Electrical engineering: from first circuits to the power grid.

Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view