Omniadisce

What the model leaves out

Lesson Beginner

Join free to take this lesson

Anyone can look around, but taking a lesson needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

3 steps ยท about 8 min ยท runs in the Beam lab

Software only checks what it was built to check. Engineers check the rest.

The idea

Every model simplifies. This lab assumes the top flange of a steel beam is held sideways by the floor it carries.

Without that restraint, a long, slender I-beam does not fail by bending in its plane: it twists and buckles sideways at a much lower load. This is lateral-torsional buckling (EN 1993-1-1, 6.3.2), and the lab does not check it.

Knowing what your software does not check is part of being an engineer.

By the end you can

  • Every calculation is a model that leaves things out.
  • This lab assumes the top flange is held sideways by the floor.
  • Without that, a long I-beam can twist and swing sideways: lateral-torsional buckling.
  • Holding the top flange (a slab or bracing) prevents it; stronger steel does not.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view