Omniadisce

Choosing a section

Lesson Beginner

Join free to take this lesson

Anyone can look around, but taking a lesson needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

4 steps ยท about 15 min ยท runs in the Beam lab

Too small fails; too big wastes steel, money and carbon. The engineer finds the one in between.

The idea

A steel beam resists bending until its whole cross-section yields: $M_{Rd} = W_{pl} \cdot f_y / \gamma_{M0}$

$W_{pl}$ (plastic modulus) depends on the shape: depth counts most, which is why beams are I-shaped: material far from the centre does the work.

The design is safe when $M_{Ed} \le M_{Rd}$. The engineer's job is the lightest section that passes.

By the end you can

  • A beam's section is its shape; I-sections put the steel where it works hardest, in the flanges.
  • Bending resistance: $M_{Rd} = W_{pl} \times f_y$, and cmยณ ร— MPa รท 1000 gives kNm.
  • A check passes when demand โ‰ค resistance, a utilisation of 100% or less.
  • The right section is the lightest one that passes every check.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view