Omniadisce

Supports push back

Lesson Beginner

Free preview: try this one without an account

Your answers are checked as you go. Join free to save your progress and continue with the rest of the course.

7 steps ยท about 10 min ยท runs in the Beam lab

Start the lesson

Shelves, floors and bridges all start with the same question: how hard must each support push to hold the load up?

The idea

A beam stays put because its supports push back. Those pushes are the reactions, and for a beam on two supports they follow from two rules of equilibrium: vertical forces balance, and moments about any point balance.

$\sum F_y = 0: R_A + R_B = P$ and $\sum M_A = 0: R_B \cdot L = P \cdot a$

Here a 20 kN load sits 2 m from the left support of a 6 m beam. Loads are unfactored in this lesson.

By the end you can

  • A beam stays up because its supports push back. Those pushes are the reactions.
  • Rule 1, up equals down: $R_A + R_B = P$.
  • Rule 2, nothing spins: about support A, $R_B \times L = P \times a$.
  • The support nearer the load carries more of it. A load in the middle is shared half and half.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view