Omniadisce

Sliding, toppling, sinking

Lesson Beginner

Join free to take this lesson

Anyone can look around, but taking a lesson needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

4 steps ยท about 15 min ยท runs in the Retaining walls lab

A wall can slide, topple or sink. It has to resist all three at once.

The idea

A wall can fail in three ways as a rigid block: it slides forward on its base, topples over its toe, or the ground under the toe gives way in bearing. Each pits the earth pressure against the wall's weight.

Sliding resistance is friction on the base: $R = V \tan\delta$, with ฮด = ฯ†' of the ground for concrete cast on it. Eurocode divides tan ฯ†' by 1.25 for the design value.

The resultant must also stay in the middle third of the base, or the heel lifts off the ground.

By the end you can

  • Walls must resist sliding, overturning and bearing failure.
  • Sliding resistance is base friction: V tan ฯ†' / 1.25.
  • The resultant must stay in the middle third of the base.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view