Supports push back
Shelves, floors and bridges all start with the same question: how hard must each support push to hold the load up? A beam stays put because its supports push back. Those pushes are the reactionsโฆ
7 posts match
Shelves, floors and bridges all start with the same question: how hard must each support push to hold the load up? A beam stays put because its supports push back. Those pushes are the reactionsโฆ
A beam breaks where it bends hardest. This lesson finds that place. Inside the beam, the material resists turning: the bending moment. Cut the beam anywhere, and the moment there equals the momentโฆ
Floors, snow and crowds spread their weight. This lesson shows why long spans are hard. Floors, snow and people spread their weight: a uniformly distributed load $w$ in kN/m. For moments, it actsโฆ
No one knows exactly what a floor will carry. Engineers plan for bad luck. Loads are uncertain and materials vary. Eurocodes deal with this with partial factors: the design load is bigger than theโฆ
Too small fails; too big wastes steel, money and carbon. The engineer finds the one in between. A steel beam resists bending until its whole cross-section yields: โฆ
A floor can be perfectly safe and still feel like a trampoline. A beam can be strong enough and still sag too much. Deflection depends on stiffness $E \cdot I$, not on strength.
Software only checks what it was built to check. Engineers check the rest. Every model simplifies. This lab assumes the top flange of a steel beam is held sideways by the floor it carries.