Omniadisce

Amplify a sensor signal 11 times

Circuit Intermediate New no attempts yet
A sensor gives $0.5\ \text{V}$; the measuring circuit after it wants about $5.5\ \text{V}$ for the same reading. An op-amp with negative feedback makes a precise amplifier out of two resistors.

The starter is a voltage follower: the output is wired straight back to the inverting (โˆ’) input, so the gain is exactly 1.

With negative feedback, the op-amp drives its output until its two inputs are at the same voltage. In the non-inverting amplifier the โˆ’ input sees the output through a divider ($R_f$ above, $R_g$ to ground), so $V_{out} = V_{in}\left(1 + \frac{R_f}{R_g}\right)$.

How to do it:
1. Delete the wire from the output back to the โˆ’ input (the follower's feedback).
2. Add a resistor R_f from the output to the โˆ’ input, and a resistor R_g from the โˆ’ input to the bottom (ground) wire.
3. Gain = 1 + R_f รท R_g must be 11, so R_f must be 10 times R_g (for example 10 kฮฉ and 1 kฮฉ).
4. Hover over the 10 kฮฉ load: it should show 5.5 V. Press Check answer.
Principles it rests on
Ideal op-amp rules under negative feedback: no input current, equal input voltages; the non-inverting gain $1 + R_f/R_g$.
Question
Add a feedback resistor and a resistor to ground so the 10 kฮฉ load gets 5.5 V (gain 11, ยฑ2 %).

Join free to take this activity

Anyone can look around, but taking an activity needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

It is part of the course Electrical engineering: from first circuits to the power grid.

Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view