Omniadisce

Why the grid uses high voltage

Circuit Intermediate New no attempts yet
A power station sends power to a town over a line whose two conductors have $5\ Ω$ of resistance each. The town needs $1\ \text{kW}$ (scaled down: think of it as 1 GW over a real line).

At 230 V the line burns away a large share of the power before it arrives, and the town does not even get its 1 kW. The line loss is $I^2 R_{line}$: for the same power, a higher voltage means a smaller current, and the loss falls with the square of the current.

How to do it:
1. The line (two 5 Ω resistors) may lose at most 50 W: I² × 10 ≤ 50, so I is at most about 2.2 A.
2. To deliver 1000 W with a current of about 1 A, the town needs about 1000 V. Set the station to 1000 V.
3. The town's resistance is then about P ÷ I² = 1000 ÷ 1² (a little less, because the line takes some voltage).
4. Set both, hover over the town's resistor to check about 1000 W, and press Check answer.
Principles it rests on
$P = VI$; resistive loss $I^2 R$; why transmission voltage is stepped up.
Question
Choose the station voltage and the town's resistance so the town receives 1 kW (980 W to 1030 W) and the station sends at most 1050 W.

Join free to take this activity

Anyone can look around, but taking an activity needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

It is part of the course Electrical engineering: from first circuits to the power grid.

Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view