Omniadisce

A Zener regulator for 5.6 V

Circuit Intermediate New no attempts yet
A Zener diode wired backwards holds its voltage close to its Zener voltage, here $5.6\ \text{V}$, as long as enough current flows through it. A series resistor drops the rest of the supply. This is the simplest voltage regulator.

The series resistor must pass enough current for both the 1 kฮฉ load and the Zener (which needs a few milliamps to regulate). Too large a resistor and the Zener switches off: the starter's 2.2 kฮฉ leaves the load with only 3.75 V.

How to do it:
1. The load takes 5.6 V รท 1000 ฮฉ = 5.6 mA. Give the Zener about 10 mA as well.
2. So the series resistor carries about 5.6 + 10 = 15.6 mA.
3. It drops 12 โˆ’ 5.6 = 6.4 V, so R = 6.4 V รท 0.0156 A.
4. Round to a standard value, check its power (Vยฒ รท R) is under 0.25 W, set it, and press Check answer.
Principles it rests on
Zener breakdown; Kirchhoff's current law at the output node; resistor power.
Question
Choose the series resistor so the load gets 5.3 V to 5.9 V, the Zener carries 5 mA to 20 mA, and no resistor exceeds 0.25 W.

Join free to take this activity

Anyone can look around, but taking an activity needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

It is part of the course Electrical engineering: from first circuits to the power grid.

Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view