Omniadisce

Build a NOT gate from a transistor

Circuit Intermediate New no attempts yet
Every digital chip is built from switches. The simplest logic gate is the inverter (NOT gate): its output is 1 when its input is 0, and 0 when its input is 1.

Here the input switch is closed (input = 1, 5 V). The transistor, with a 1 kฮฉ collector resistor, is the gate; the LED shows the output (lit = 1). With the starter's 10 Mฮฉ base resistor, the transistor barely conducts, so the output stays high and the LED stays lit: the gate does not work.

How to do it:
1. With the switch closed (input 1), the transistor must turn fully on, so the output is pulled near 0 V and the LED goes dark.
2. Fully on needs a collector current of about 5 V รท 1 kฮฉ = 5 mA, so a base current of at least 0.05 mA; aim for about 0.4 mA.
3. The base resistor has 5 โˆ’ 0.7 = 4.3 V across it: R = 4.3 V รท 0.0004 A.
4. Set the base resistor, check the LED is dark, press Check answer, then click the switch to test the other input.
Principles it rests on
The BJT as a saturated switch; logic levels; resistor-transistor logic (RTL).
Question
Choose the base resistor so an input of 1 gives an output of 0 (LED dark), with the supply giving at most 6 mA.

Join free to take this activity

Anyone can look around, but taking an activity needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

It is part of the course Electrical engineering: from first circuits to the power grid.

Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view