Omniadisce

Smooth a rectified supply

Circuit Intermediate New no attempts yet
A transformer winding gives a 12 V peak, 50 Hz sine wave. Four diodes in a bridge flip every negative half-cycle positive, so the 100 Ω load gets pulses of one polarity, 100 of them a second. A capacitor across the load charges at each peak and supplies the load between peaks.

Between peaks the capacitor discharges and the voltage sags by the ripple $\Delta V \approx \frac{I}{2 f C}$ (two peaks per cycle). The starter's 100 µF lets the voltage sag by several volts.

How to do it:
1. The peak output is about 12 − 1.4 = 10.6 V, so the 100 Ω load draws about 0.106 A.
2. Between peaks (10 ms apart) the capacitor alone feeds the load. The ripple is I ÷ (2 × f × C).
3. For a ripple of 1 V: C = 0.106 ÷ (2 × 50 × 1). Choose a standard capacitor at least that large.
4. Double-click the capacitor, set it (you can type 2200u), and press Check answer.
Principles it rests on
Full-wave rectification; capacitor discharge $\Delta V = I\,\Delta t / C$.
Question
Choose the smoothing capacitor so the ripple is at most 1 V (C between 1.06 mF and 10 mF).

Join free to take this activity

Anyone can look around, but taking an activity needs a free account. With one, your answers are checked step by step and your progress is saved, so you can stop and pick up where you left off on any device.

It is part of the course Electrical engineering: from first circuits to the power grid.

Nobody has tried this yet.Be the first. Your answer starts the stats.

Only each person's first answer, given before viewing the solution, is counted.

Discussion 0 comments

Log in to join the discussion.

× Enlarged view